ELECTROLUX-REX PX780UOV Manual de usuario descargar pdf (Pagina 12)

5.

Replace the rating label (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this label in the package of the injec-

tors supplied with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.3 Adjustment of minimum level

To adjust the minimum level of the burner:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the control knob.

4.

With a thin screwdriver, adjust the by-

pass screw position. If you change

from natural gas 20 mbar to liquid

gas, fully tighten the adjustment

screw in. If you change from liquid

gas to natural gas 20 mbar, undo the

by-pass screw approximately 1/4 of a

turn for screw B, 1/3 of a turn for

screw A.

A

B

A)

Minimum adjustment screw for

dual burner both crowns

B)

Minimum adjustment screw for

dual burner internal crown

5.

Make sure the flame does not go out

when you quickly turn the knob from

the maximum position to the mini-

mum position.

8.4 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a cor-

rect plug which can hold the load that

the rating plate rates. Make sure that

you install the plug in a correct socket.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• There is a risk of fire when the appli-

ance is in connection with an extension

cable, an adapter or a multiple connec-

tion. Make sure that the ground con-

nection agrees with the standards and

regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

To prevent contact between the cable

and the appliance below the hob use the

clamps which are on the side of the cabi-

net.

A

A)

Rigid copper pipe or flexible pipe of

stainless steel

8.5 Replacement of the

connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown

(or black) phase wire.

12

www.electrolux.com

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios