ELECTROLUX-REX PX980UOV Manual de usuario descargar pdf (Pagina 12)

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end) (UNI-

CIG 7129).

Flexible connection:

Use a flexible pipe in stainless steel (UNI-

CIG 9891) with a maximum length 2 m.

When installation is complete,

make sure that the seal of each

pipe fitting is correct. Use a soapy

solution, not a flame!

8.2 Injectors replacement

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in Technical

information chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating label (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this label in the package of the injec-

tors supplied with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.3 Adjustment of minimum level

To adjust the minimum level of the burner:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the control knob.

4.

With a thin screwdriver, adjust the by-

pass screw position. If you change

from natural gas 20 mbar to liquid

gas, fully tighten the adjustment

screw in. If you change from liquid

gas to natural gas 20 mbar, undo the

by-pass screw approximately 1/4 of a

turn for screw B, 1/3 of a turn for

screw A.

A

B

A)

Minimum adjustment screw for

dual burner both crowns

B)

Minimum adjustment screw for

dual burner internal crown

5.

Make sure the flame does not go out

when you quickly turn the knob from

the maximum position to the mini-

mum position.

8.4 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a cor-

rect plug which can hold the load that

the rating plate rates. Make sure that

you install the plug in a correct socket.

12

www.electrolux.com

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios