ELECTROLUX-REX PX980UOV Manual de usuario descargar pdf (Pagina 13)

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure

adjuster on the gas supply pipe.

8.4 Adjustment of minimum level

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A for external

crown and B for internal crown).

A

A

B

5. If you change:

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING!

Make sure the flame does not

go out when you quickly turn

the knob from the maximum

position to the minimum

position.

8.5 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supplied with a

correct plug which can hold the load

that the rating plate rates. Make sure

that you install the plug in a correct

socket.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that the

ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

To prevent contact between the cable and

the appliance below the hob use the

clamps which are on the side of the

cabinet.

ENGLISH

13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios