ELECTROLUX-REX PZ-T1OV Manual de instalación descargar pdf (Pagina 10)

Adjustment to different types of gas

Replacing the nozzles

1. Remove the grids.

2. Remove the grid caps and burnes’ crowns.

3. With a 7 socket spanner unscrew and take out the

nozzles (picture 13), substitute them with those

corresponding to the working gas type (see table next

page).

4. Reassemble the parts/elements by executing the

above described operations in the opposite direction.

5. Substitute the calibration rating plate (positioned near

the feed ear). This last one is in the small bag of the

injectors’ kit.

If the pressure of the gas applied is different (or variable)

from the scheduled one, it is necessary to install on the

inlet tube, a proper pressure regulator for gases (NOT

GPL) in compliance with the UNI-CIG 7430.

The employment of pressure regulators for liquid gas

(GPL) is allowed if complying with UNI-CIG 7432.

Picture 13

Adjusting the minimum gas setting of taps.

To adjust the minimum setting proceed as follows:

1. Light up the burners as previously described.

2. Turn the gas cock to the minimum position.

3. Take the knobs out..

4. Work on the by-pass pin indicated on picture 15.

• If you pass from Methane to GPL gas, screw tight

the by-pass pin in the clockwise direction.

• In any case the result must be a small,

homogeneous and regular flame in the entire

burner’s crown. .

5. Verify then that by turning quickly the tap from the

maximum to the minimum position, no burner’s

blowing-out occurs.

The described adjustment’s operations can be easily

done in any positioning of the hob on the kitchen

furniture.

Picture 15

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

ELECTROLUX-REX PZ-T1OV Manual de instalación Pagina 10