ELECTROLUX-REX PZ-T1OV Manual de instalación descargar pdf (Pagina 7)

Discharge of flue gases

Cooking appliances must always discharge the flue

gases into special hoods, which must be connected to

chimneys or have direct access to the outside.(picture7).

If it is not possible to install a hood, it is necessary the

employment of an electric fan fitted to the external wall

or to the window, as long as there are the conditions for

the increase of the ventilation (see picture 8), reported to

the power of the fan itself. (UNI-CIG7129).

This electric fan must have the necessary power to

grant, for a kitchen, an hour air change of 3-5 times its

volume.

Picture 8

Picture 9

Connection to the gas-supply.

The cooker should be connected according UNI-CIG

7129 – 7131 directives. The appliance is tested and

adjusted to operate with the type of gas stated on the

rating plate applied in the inferior protection, closed to

the connection gas-supply pipe.

Make sure the type of gas you will use to feed the

appliance is the same indicated on the label.

In the contrary case proceed referring to the paragraph “

Adjustment to the different gas types”.

For the best performance and the lowest consume,

make sure that the gas pressure respect the values

indicated in the table “Features of the burners”.

If the applied gas pressure is different (or variable) from

the scheduled one, it is necessary to install, on the inlet

pipe, a proper gas pressure regulator for gas (NON

GPL) in compliance with UNI-CIG 7430.

The use of pressure regulators for liquid (GPL) is

permitted but it has to be in appliance to the UNI-CIG

7432 Directive.

On the terminal part of the ramp with a thread nut G 1/2”

the pipe fitting has to be mounted, putting between the

parts, the washer as indicated in picture 9. Screw the

parts without forcing, position the washer toward the

requested direction and tighten everything.

Gas connection

The connection of the hob to the gas pipe network must

be made by means of a rigid metallic pipe complying

with the UNI-CIG 7129 directive or using a flexible

connection according the UNI-CIG 9891 directive, which

can be extended to a maximum length of 2 metres. Pay

attention, in case of employment of flexible metal pipes,

they do not get in touch with moving parts or get

crushed. Pay attention even if you combine a hob and

an oven. The gas inlet washer in the appliances is

thread ½” male cylinder. Carry out the gas connection

avoiding any sort of stress to the appliance.

At complete gas connection, always verify the

perfect hold of all the washers by using a soapy

solution. Never carry out this control using a flame

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios

ELECTROLUX-REX PZ-T1OV Manual de instalación Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para No ELECTROLUX-REX PZ-T1OV