ELECTROLUX-REX PZ-T1OV Manual de instalación descargar pdf (Pagina 8)

Electrical connection

The appliance is set up for a single-phase 230V feeling

voltage. The connection has to be carried out in

compliance with the current directives and law

dispositions.

Before connecting the hob make sure that:

The shaping valve and the electrical system can stand

the appliance load (see the serial number indicated on

the rating plate):

The feed system of the appliance has a proper earth

connection, according the laws in force;

The tap or the single-pole circuit breaker are easy to be

reached from the installed appliance.

Mount on the cable a suitable tap for the load and

connect it to a proper safety tap.

If a straight connection to the electricity is desired, it is

necessary to put a single-pole, with a minimum opening

of 3mm dimensioned to the load and in compliance with

the current directives, between the appliance and the

network.

The brown phase wire (coming out from the L terminal

on the terminal board) must be always connected to the

phase of the feeding network.

In any case the feeding wire has to be positioned so that

it cannot reach, anywhere in its length, a temperature

higher than 90°C.

An example of optimal current path is indicated on

picture 10. The wire is guided by the employment of

clamps fixed on the side of the furniture, in order to

avoid any contact with the appliance under the hob

Picture 10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

ELECTROLUX-REX PZ-T1OV Manual de instalación Pagina 8